Shop by Vehicle
Wire Harnesses
Relay Harnesses for HID Retrofits and Lighting Upgrades
A lot of people assume the factory headlight wiring can just power an HID ballast the same way it powered the halogen bulb. It can't, not reliably anyway. That factory circuit was only ever designed to run a halogen bulb, which means an HID ballast pulling steady current through it is going to cause flickering, a delayed startup, or worse down the road. A relay harness fixes that by feeding power straight from the battery through a fused, high-capacity cable, using the factory connector only as a trigger signal.
Our HD relay harnesses run two relays, one per side, so each ballast gets independent power. When you mount them, use the bracket and make sure both relays face upward. That small detail keeps moisture out of the contacts and is the difference between a harness that lasts the life of the car and one that corrodes out in a couple seasons. Worth noting: a lot of domestic platforms, Camaros and late model Ford and Chevy trucks especially, also benefit from adding an anti-flicker capacitor alongside the relay harness since their factory load monitoring can get fussy with aftermarket ballasts.
If you are putting together a full retrofit, the harness is not something to pick last. I would start by looking at our Universal Retrofit Kits, since the relay harness setup and the projector hardware need to work together from the start rather than getting bolted on as an afterthought.