Shop by Vehicle
Banger Fog Lights
Morimoto 4Banger Fog Lights: NCS vs HXB Guide
If you are shopping for a plug and play LED fog light upgrade for your truck or SUV, the 4Banger platform is built around exactly that problem: a compact pod, a vehicle-specific bracket, and a factory harness connection with no cutting required.
What actually separates NCS from HXB. NCS runs a Nichia NCSY131F chip rated 1,300lm raw per pod at 15.6w (1.5A), while HXB steps up to an Osram HX Boost chip rated 3,000lm raw at 42w (3.2A). After warm-up that gap shows up as real intensity: NCS Yellow measures 8,680 Cd, NCS White 14,400 Cd, HXB Yellow 14,700 Cd, and HXB White tops out at 22,400 Cd. All figures are per pod.
Worth noting: brighter is not automatically better for fog duty. NCS is the pod we recommend for true fog, since the HXB beam runs too centrally intense and acute for actual fog conditions and is prone to glare if aim is not set low. The 2 and 4-Banger both pass SAE in NCS and HXB, though HXB SAE results vary unit to unit on the 4-Banger. HXB earns its keep for snow and general off-road visibility, but if the job is fog, NCS is the one to buy.
Morimoto Banger Fog Light Brackets for 20-22 Ford Super Duty (OE LED Trucks) | Install & Overview
This walkthrough shows the bracket and 2-pin Deutsch DT connection going in on a Super Duty, the same plug and play approach used across the vehicle-specific kits. Then, if your rig calls for a different pod housing or you are building a universal A-pillar setup instead of a factory fog swap, it is worth comparing the XB LED Fog Lights lineup before you order.
Bottom line on choosing and fitting a kit
Every 4Banger fog kit ships with stainless hardware, molded UV-resistant ABS brackets and bezels, and a complete plug and play wiring kit, which means there is no splicing into factory wiring on either Ford or Toyota applications. Bracket fitment is vehicle specific. The Raptor kit uses bracket BAF024, and the 4Runner has two distinct kits depending on generation (FOGKIT45 for 10-13, FOGKIT46 for 14-24, both built around the BAF014 bracket), so match your year before you buy rather than assuming one bracket covers both. From there, installation follows the same pattern on nearly every application: unplug the factory fog connector, plug it into the 4Banger, set the pod in the bracket, and reinstall.
Start by confirming your exact year and trim, then choose NCS if this is going in a true fog light location and HXB if you are after maximum output for off-road or snow use. If you are also upgrading the bulbs elsewhere on the truck, our LED Fog Light Bulbs page is worth a look while you are at it.
68 Results
NCS Wide Beam / White or Yellow
MorimotoHigh Performance LED Fog Lights
MorimotoHigh Performance LED Fog Lights
Morimoto